Tambor accionado por un solenoide

Make

Procesador de 2-bit en papel, te ayuda a entender como trabajan los microprocesadores

Hack a day

Un simulador de un procesador 6502 es visualmente real

Adafruit

Controla una lampara con un ATTiny2313 via bluetooth con un celular Android

Adafruit

Cable USB-Serial reusado para dar USB a un proyecto

Hack a day

Generador Van de Graaff DIY

Make

Matriz de sensores de presión

Hack a day

Los diez mandamientos del buen soldador de electronicos

"The Ten Commandments" For Electronic Soldering
(A COOPERTools Reprint)

Thou shall not remove tip from soldering iron when power is "On". Causes heating element to rise in temperature to approximately 1300 F resulting in thermal shock and reduced heater life.   Thou shall maintain a damp (NOT drenched) iron sponge (preferably with de-ionized water). A drenched sponge will bring the temperature of the tip down too drastically, causing thermal shock and reduced tip life.   Thou shall not disconnect soldering iron from base unit when power is turned "On". Disconnecting or reconnecting the soldering tool from the base unit with power applied may cause a short between non-compatible pins resulting in damage to the base unit or pencil.   Thou shall maintain a coating of solder on working area of soldering iron tip. Protects the tip from oxidation.   Thou shall never drop soldering iron while heated. Dropping the soldering tool while heated may cause thermal/mechanical shock to the heater, sensor, or tip (fractured plating).   Thou shall not throw soldering iron into soldering tool stand. See Commandment V.   Never use soldering iron as a crowbar or pry tool. Could chip or pit finish on tip rendering it useless.   Using sharp or serrated objects to remove tip from soldering iron is forbidden. See Commandment VII.   Honor thy "KGB" (Known Good Base). Do not plug a non-working soldering iron into a KGB. Could cause damage to the base.   Thou shall turn station down to lowest setting during daily usage when not being used. Turning the station down during non use periods will prevent severe thermal cycling of the tool. However, tools not being used for extended periods of time should not be left on indefinitely. Make

Soldando componentes SMD

Make

Haciendo cable electroluminiscente paso a paso

Make



Otro artículo en Make

Aumentando la fuerza de un transmisor infrarrojo

Hack a day

Construyendo un convertidor analagico-digital discreto

Hack a day

Mini Tanque seguidor de línea sin usar un microcontrolador

Hack a day

Una colección de seguidores de línea bastante rápidos

Hack a day

Como hacer tus propios sensores para LEGO Mindstorms

Hack a day

Usando un sensor de 5 grados de movimiento Acelerómetro/Giroscopio

Starlino

Como construir un radio con solo un opam y algunos otros componentes pasivos

Jo0ngle en Youtube

Transmisor de radio de hasta 200 millas

Hack a day

Construyendo redes de sensores inalambricos

Adafruit

Alama vía celular

Hack a day